DOWSIL™ EG-3810 Dielectric Gel
One-part, low/high temperature gel.
These values are typical properties and are not intended for use in preparing specifications.
- Color Yes No Clear, Colorless
- Dielectric Constant at 100 kHz Yes No 2.9
- Dielectric Constant at 1MHz Yes No 2.9
- Dielectric Strength (kV/mm) Yes No 21 kV/mm
- Heat Cure Yes No 30 Minutes @ 100 Deg C, 10 Minutes @ 150 Deg C
- Number of Parts Yes No One
- Viscosity Yes No 690 mPa.s
DOWSIL™ EG-3810 Gel delivers long-lasting performance as a protective potting material for power conversion applications, such as insulated gate bipolar transistor (IGBT) modules. Its unique combination of thermal stability and low modulus also make it an appealing solution for automotive electronics, sensors, and actuators that must operate reliably over large temperature ranges.
Frequently Bought Together
DOWSIL™ EI-1184 Optical Encapsulant
A 1:1 mix ratio, fast curing, 2-part silicone encapsulant suitable for encapsulating rigid and flexible circuit boards indoor and outdoor LED Lighting applications.
DOWSIL™ 1-2577 Conformal Coating
One-part, transparent medium viscosity conformal coating with firm, abrasion resistant surface after cure.
SILASTIC™ MS-1002 Moldable Silicone A&B Kit
A medium viscosity, high Shore A hardness, two-part, 1 to 1 ratio, fast curing optical molding resin for producing fine detail with good resistance to environmental aging.
DOWSIL™ 1200 OS Primer
An air drying primer supplied as a dilute solution of moisture reactive materials in volatile siloxane and is used to improve both the quality and speed of adhesion development to room temperature vulcanizing silicone sealants to a variety of common non-porous substrates.
No Safety Data Sheets are available online for this material Please Contact Dow for additional information.
No Safety Data Sheets are available online for this material
Please Contact Dow for additional information.