STYROFOAM™ DECKMATE™ Plus FA

Conventional Roof Sales Brochure (446KB PDF)
STYROFOAM™ DECKMATE™ Plus Sales Brochure (428KB PDF)
STYROFOAM DECKMATE Plus FA & INSTA STIK™ Quik Set Sell Sheet (160KB PDF)
STYROFOAM DECKMATE Plus FA (flat and tapered) Product Information Sheet (101KB PDF)
Rigid Polystyrene Roof Board Insulation - Fully Adhered (STYROFOAM DECKMATE Plus FA Guide Specification) (41KB PDF)
STYROFOAM DECKMATE Plus Direct-to-Deck Application Information Sheet (180KB PDF)

STYROFOAM™ DECKMATE™ Plus FA insulation is an extruded polystyrene insulation with a planed surface. It has excellent insulating characteristics, high resistance to water and water vapor, excellent freeze-thaw resistance, superior compressive strength and long-term durability.

STYROFOAM DECKMATE Plus FA insulation is designed for use in fully adhered conventional low-slope roof applications. Available in flat and tapered board stock (see Table 1 for slopes of tapered panels), the rigid foam insulation boards can be installed directly on structural steel decks beneath a non-bituminous sheet membrane, eliminating the need for a thermal barrier.

Nominal Board Thickness**	R-Value^†	Board Size	Edge Treatment	Min Compressive Strength^† ^†
1-1/2"	7.5	24" x 96"	Square Edge	50 psi
2"	10	24" x 96"	Square Edge	50 psi
2-1/2"	12.5	24" x 96"	Square Edge	50 psi
3"	15	48" x 96"	Square Edge	50 psi
4"	20	48" x 96"	Square Edge	50 psi

Building Code Compliance

STYROFOAM™ DECKMATE™ Plus FA insulation complies with the following codes:

Meets IBC/IRC requirements for foam plastic insulation; see ICC-ES NER-699
ICBO-ES ER-2257
ICBO-ES ER-5155
BOCA-ES RR 21-02
Underwriters Laboratories, Inc. (UL) Classified, see Classification Certificate D369
Factory Mutual Approved - Subject to conditions of approval as a roof insulation when installed as described in the current edition of FM Approval Guide
CCMC - Evaluation Listing #12085-L

**Not all product sizes are available in all regions.
^† R means resistance to heat flow. The higher the R-value, the greater the insulating power. R-values are expressed in ft2•h•°F/Btu.
^† ^† Vertical compressive strength is measured at 10% deformation (5% for STYROFOAM PLAZAMATE insulation and for STYROFOAM HIGHLOAD 40, 60 and 100 insulation products) or at yield, whichever occurs first. Since STYROFOAM extruded polystyrene and Dow polyisocyanurate insulation products are visco-elastic materials, adequate design safety factors should be used to prevent long-term creep. For static loads, 3-1 is suggested. For dynamic loads, 5-1 is suggested.

	SEARCH
	SELECT